Bosch DLA-AIOU0 Guía De Instalación Rápida página 20

20 en | System Setup – First Steps
–
2.2 Unpacking
You should inspect the box the system was shipped in and note if it was damaged in any way.
If the system itself shows damage you should file a damage claim with the carrier who
delivered it and notify the respective Bosch RMA desk.
Due to the weight of the system: After opening the top of the shipping box, one person should
stand at either end and lift the disk array out together.
Decide on a suitable location for the system. The system should be situated in a clean, dust-
free area that is well ventilated. Avoid areas where heat, electrical noise and electromagnetic
fields are generated. You will also need it placed near a grounded power outlet. Be sure to
read the Precautions in the next section.
2.3 Preparing for Setup
Follow the steps in the order given to complete the installation process in a minimum amount
of time. Read this section before you begin the installation procedure outlined in the sections
that follow.
2.3.1 Choosing a Setup Location
Leave enough clearance in front and side where the chassis cover is located of the system to
be able to remove swappable drives and to allow for sufficient airflow and ease in servicing.
This product is for installation only in a Restricted Access Location (dedicated equipment
rooms, service closets and the like).
2.3.2 System Precautions
–
–
–
–
2.4 Powering On the System
The last thing to be done is to provide input power to the system.
1.
2.
3 System Setup – First Steps
3.1 Introduction
The following installation directive applies to the Bosch DLA disk array series and provides
information on Installation, Configuration and Service and Repair.
- | V1 | 2011.03
In addition to the system itself, the following items should have been shipped along with
each system
– One AC power cable for each power supply in the system
– This quick install guide
Review the electrical and general safety precautions.
Use a regulating uninterruptible power supply (UPS) to protect the system from power
surges, voltage spikes if you want to keep your system operating in case of a power
failure
Allow the SATA drives and power supply modules to cool before touching them.
Always keep the chassis covers in place and secured when not servicing to maintain
proper cooling.
Plug the power cord from the power supply unit into a high-quality power strip that
offers protection from electrical noise and power surges. We recommended using an
uninterruptible power supply (UPS).
Press the power button on the control panel to start up the system.
Quick Installation Guide
1200 Series/4-bay IP Video Storage System
Bosch Sicherheitssysteme GmbH