Publicidad
Idiomas disponibles
Idiomas disponibles
Electrical and Structural Requirements (Continued)
Deep box with brace (Figure 3)
Paired with a deep box, this hanger is meant to span
between two joists and takes the place of wooden
blocking.
WARNING
To reduce the risk of fire, electric shock, or personal
injury, mount to outlet box marked acceptable for fan
support of 15.9 kg (35 lbs) or less and use mounting
screws provided with the outlet box. Most outlet boxes
commonly used for the support of luminaires are not
acceptable for fan support and may need to be
replaced, consult a qualified electrician if in doubt.
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and
remove the existing light fixture.
WARNING
Turning off wall switch is not sufficient. To avoid
possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring. All
wiring must be in accordance with National and
Local codes and the ceiling fan must be properly
grounded as a precaution against possible electrical
shock.
WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a
licensed electrician.
1. Cut off excess lead wire approximately 6 to 9
inches above top of the downrod. Strip insulation
off
1/2 inch from the end of each lead wire. (Figure 1)
NOTE: All set screws must be checked, and retightened
where necessary, before installation.
How to Assemble Your Ceiling Fan
CEILING
5
CEILING JOIST
OUTLET BOX
Figure 3
Figure 1
Publicidad
