Operation - Hayward AquaVac 250 Manual De Usuario

OPERATION

WARNING!
Make sure the robot is off.
1. Bring your robot to the side of your pool. NOTE: Do not place the robot in the pool corner and
against the pool wall as starting location. Attach the hook of the float to the handle of the
swivel head. Press on the side clip to eject the stem from the float. Release the rope from the
stem to a length equivalent to the depth of pool water plus an excess of about 0.5 meters (1.6
feet). Once the desired length has been achieved, maintain it by holding onto the rope on the
stem and reattach it to the float by pressing on the side clip as shown.
2. Slide the power switch to the ON position and the power indicator lights will turn on.
ATTENTION: Motor activates only when the robot is submerged in water completely.
Power indicator lights
3. Immerse the robot into the water and operation will automatically begin as water level covers
the sensors at the top of the swivel head. Let the robot sink to the pool floor and observe the
cleaner's first forward and reversed movements across the pool bottom. If the robot runs
along the pool wall instead of perpendicular to it, reposition it to make sure that its front/back
faces the pool wall.
IMPORTANT NOTE: The swivel head may rotate repeatedly for a few minutes once the
robot sinks to the pool bottom. This phenomenon will stop once the air trapped inside the
robot is gradually discharged and the robot will begin to move regularly.
(Green)
12