Getting Started; Charging The Battery - Hayward AquaVac 250 Manual De Usuario

GETTING STARTED

Charging The Battery

IMPORTANT NOTE: Fully charge the robot (about 5-6 hrs) before using it for the first time.
WARNING!
 Use only the original external adaptor and charging base provided.
 Make sure the robot and the charging port are clean and dry before set-up.
 Make sure the robot is off by sliding the switch to the OFF position prior to charging.
1. Place the unit on a flat surface. Slide the switch to the OFF position.
2. Place the unit on a flat surface. Plug the socket of the charging base into the built-in charging
pins once they are aligned. WARNING! Be sure not to invert the charging base. Plug the
charging cable of the external adaptor
3. Connect the external adaptor to the power source. Once the robot begins charging, the
indicator light on the external adaptor will turn red.
The indicator light on the external adaptor will turn green when the robot is charged. Charge
it for 5-6 hours for best performance.
 Immediately disconnect the external adaptor from the power source if you detect any of the
following:
- Offensive or unusual odor
Excessive heat
-
OFF
ON
RED light - Charging
GREEN light - Charged
8