Philips GC6620/20 Manual Del Usuario página 8

ENGLISH
8
Safety auto-off mode (specific types only)
- To save energy, the steam generator switches off automatically when it has not been used for
15 minutes. The 'iron ready' light flashes.
- To reactivate the steam generator, set the on/off switch to 'off ' position and then to 'on' position.
Troubleshooting
This chapter summarises the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for
a list of frequently asked questions or contact the Consumer Care Centre in your country.
Problem
The iron does
not produce any
steam.
The Calc-Clean
light flashes and
the appliance
beeps.
The Calc-Clean
light flashes and/
or the appliance
beeps.
The Calc-Clean
light flashes and
the appliance
beeps every time
I press the steam
trigger. No steam
comes out of the
soleplate.
The appliance has
switched off.
4239_000_9025_3_Booklet Simple_A5_v4.indd 8
All manuals and user guides at all-guidesbox.com
Possible cause
There is not enough water in
the water tank.
You have not pressed the steam
trigger.
You have set the temperature
dial to 1.
The steam function has been
disabled until you have
performed the Calc-Clean
process.
This is the Calc-Clean reminder.
You have not done or have not
completed the Calc-Clean
process.
You have not done or have not
completed the Calc-Clean
process.
The safety auto-off function was
activated. This happens
automatically when the steam
generator has not been used or
the steam trigger has not been
pressed for more than 15
minutes.
Solution
Fill the water tank beyond the MIN
indication. Press and hold the steam trigger
until steam comes out. It may take up to
30 seconds until steam comes out.
Press and hold the steam trigger until
steam comes out.
Turn the temperature dial to 2 or higher.
Perform the Calc-Clean process to
restore the steam function (see chapter
'IMPORTANT - Cleaning and
maintenance').
Perform the Calc-Clean process within
1 hour after the Calc-Clean reminder
is given.
Perform the Calc-Clean process to enable
the steam function again (see chapter
'IMPORTANT - Cleaning and
maintenance').
Perform the Calc-Clean process to enable
the steam function again (see chapter
'IMPORTANT - Cleaning and
maintenance').
Set the on/off switch to 'off ' position and
then to 'on' position.
6/2/15 10:06 AM