Publicidad
Idiomas disponibles
Idiomas disponibles
Replacing the side brush
Side brush
1
Screws
2
1. Unscrew the 3 screws on the underneath.
2. Remove the side brush.
3. If necessary, clean the mount.
4. Connect the new side brush to the driver and fasten it in place
with the screws.
Replacing the dust filter
DANGER
Health risk from dust
Wear a dust mark and safety goggles when working on the filter
system.
Dust filter (flat filter)
1
Frame
2
Hold-down plate
3
1. Shut down the device safely.
2. Clean the dust filter with the manual filter cleaner.
3. Completely open and secure the cover.
4. Remove the hold-down plate.
5. Remove the dust filter upwards.
6. As necessary: Clean the dust filter. (vacuum or carefully tap it
out) or insert a new dust filter.
Replacing / setting the sealing strips
Sealing strips
Settings
Side sealing strips
Distance from floor 2 - 3 mm
Front sealing strip
Trailing distance 10-15 mm
Rear sealing strip
Trailing distance 5-10 mm
Note
The trailing distance of the front and rear sealing strip defines
how much the sealing lip folds backwards when driving the de-
vice forwards.
When set correctly, there must be a gap between the side sealing
strips and the floor.
Fastening
1
Side sealing strip
2
Front sealing strip
3
Rear sealing strip
4
1. Unfasten the fastening of the sealing strips.
2. Set the sealing strip by shifting it in the elongated holes.
3. Refer to the table for the values.
4. Once the settings are correct, fasten the sealing strips.
Jack
1
Rear wheel
2
Washer
3
Screw
4
Sleeve
5
1. Unfasten the screw a little, do not completely unscrew it.
2. Lift the device with the jack at the attachment point.
3. Unscrew the screw, remove the washer from the sleeve.
4. Remove the rear wheel from the axle.
5. Put on a new rear wheel and tighten the screw, washer and
sleeve.
Beware of the feather key!
English
Replacing the rear wheel
25
Publicidad
