Publicidad
Idiomas disponibles
Idiomas disponibles
Operating Instructions and Parts Manual
GENERAL SAFETY INFORMATION (CONTINUED)
Pump motor is equipped with an automatic
resetting thermal protector and MAY restart
unexpectedly. Protector tripping is an indication of motor overheating
because of operating pump at low heads (low discharge restriction),
excessively high or low voltage, inadequate wiring, excessive surrounding
air temperature, inadequate ventilation, and/or defective motor or pump.
5.
Provide a means of pressure relief in the case of an obstructed
discharge line.
6.
Protect electrical cord from sharp objects, hot surfaces, oil and
chemicals. Avoid kinking the cord and replace damaged cords
immediately.
This product contains a chemical that is known to the State of
California to cause cancer or birth defects or other reproductive
harm.
All manuals and user guides at all-guides.com
INSTALLATION
ALWAYS disconnect power source before attempting to
operate, service, or maintain the pump. NEVER handle a pump
with wet hands or when standing on wet or damp surface or
in water. Fatal electrical shock WILL occur.
1.
Risk of electrical shock! This pump is supplied with a
grounding conductor and grounding type attachment plug.
A grounded receptacle in conformance with current NEC and
local codes must be used (See Figure 1).
Figure 1
2.
3.
Wire Size
Length
Risk of fatal electrical shock. NEVER cut off the round
grounding prong. Cutting the cord or plug WILL void the
warranty and make the pump inoperable.
2
A ground fault circuit interrupter (GFCI) is required.
GROUNDING BLADE
GFCI RECEPTACLE
This pump operates on 115V, 60 Hz AC, single phase or 115V
DC.
Use an extension cord only if necessary. Follow the Extension
Cord Length Table for proper gage of 3-wire, grounding type
extension cord.
Extension Cord Length Table
#18
#16
25 ft
50 ft
TEST
RESET
#14
#12
100 ft
150 ft
Publicidad
