Publicidad
Idiomas disponibles
Idiomas disponibles
- Default settings
Press [Enter] to reset all fixture personalities (not the adjusting functions) to the default values. On the
display will appear „rSt" meaning that the fixture makes the reset. See the table of personality setting and
their default positions.
- Adjusting the default positions of colour, gobo and effect wheels
By this function you can calibrate and adjust the colour, gobo and effect wheels to their standard/right
positions. Use the [Up] and [Down] keys to browse through the adjusting menu - the display shows step by
step these messages: „PAn, Tilt, SPEd, Colo, CYan, MAGE, YELL, MACr EFEC, Stro, dimr, FCAL" by
which you can adjust the fixture to the required / desired position (0-255) before the function calibration.
Then when the positioning is finished use the last "FCAL" function (Fixture calibration).
1. Calibration via the control board
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, CYan,
MAGE, YELL" for very smooth function calibration. Select one of them, press [Enter] and use the [Up] and
[Down] keys in order to adjust their right value from 0 to 255. Then press [Enter] to confirm or [Mode] to
cancel and return to the menu. This can be repeated for each calibration parameter if it is required. When the
calibration is finished, it is necessary to use the "ArES" function in order to write the calibration values to the
memory (EEPROM) and to make a reset in order to check the newly adjusted positions of the colour, gobo
and effect wheels. When the reset of the fixture is finished, the display will show the "FCAL" message.
Press [Enter] to repeat the calibration or [Mode] to return to the "AdJ" menu.
2. Calibration via the external controller
Press [Enter] and the [Up] and [Down] keys in order to display the following messages: "Colo, CYan,
MAGE, YELL" - calibration parameters. Select one of them and press [Enter].
Now you can calibrate the colour, gobo and effect wheel by your controller. The DMX calibration protocol is
described in the table mentioned below.
All manuals and user guides at all-guides.com
Personality
Display
Pan reverse
Tilt reverse
Resolution
Lamp on
automatically
Display
blackout
Display
intensity
Lamp off via
DMX
Fan speed
38
Default values
(Shaded)
Publicidad
