Publicidad
Idiomas disponibles
Idiomas disponibles
SWS96285RD
ATTENTION: Refer to the appropriate shop manual for your vehicle to obtain specific service procedures for this part. If you do not have a service
manual or lack the skill to install this part, it is recommended that you seek the services of a qualified technician. Pay special attention to all
cautions and warnings included in the shop manual. Read and follow all instructions carefully. This product is only designed to function properly on
specific vehicle applications. Please verify that the vehicle requirements match the product specifications and application notes for this part.
STEP 34: Remove stabilizer links from threaded
bullets. Swing links up as high as possible against the
frame rail, making sure there is no interference or
binding of the links. Mark both areas. Using an H drill
bit, drill holes in the marked areas on the frame. Using
a M8 x 1.25 tap, thread holes for mounting cylinders.
NOTE: Quick disconnect mounting post installation is
not required for use. Zip ties may be used to support
sway bar and stabilizer links when disconnected for
off-road use. Proceed to Step 36. Please verify
with local laws that installation meets vehicle
modification guidelines.
STEP 35: Fasten end link mounting cylinders to the
frame using included M8 x 1.25 cap screws. Tighten to
15 ft-lbs. NOTE: Do not overtighten.
Even though every attempt is made to ensure this information is complete and accurate, it is impossible to account for all possible circumstances or situations. Please consult with a qualified auto
technician before attempting to perform any work you are not qualified to do. Automobiles can be hazardous to work on; be sure to take all necessary safety precautions. Failure to do so may result in
property damage or personal injury. Certain motor vehicle standards and performance requirements may apply to your motor vehicle (such as Federal Motor Vehicle Safety Standards by the National
Highway Traffic Safety Administration). Be sure that your work is performed in accordance with such standards and that you do not disable any motor vehicle safety feature.
Dorman Products, Inc. | Corporate Office and Customer Service: 1-800-523-2492
©2022 No reproduction in whole or in part without prior written approval.
INSTALLATION INSTRUCTIONS:
STEERING WOBBLE KIT
Mark location for disconnect mounting post.
Sway bar should remain positioned at 10 degree
setting w/opposite side attached. Post should be
positioned at highest location without interference
of surrounding components.
Disclaimer:
18
SWS96285RD_Instructions
Publicidad
