Features and Controls
Compare the illustrations with your generator to familiarize yourself with the locations of various controls and product
warnings .
CO Detection™
Carbon Monoxide
(CO) Shutdown
Indicator Light
Engine
Switch
Low Oil
Shutdown
Circuit Breakers
120 Volt AC, 20 Amp, GFCI Duplex Receptacle — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads .
120 Volt AC, 30 Amp Travel Trailer Receptacle — May
be used to supply electrical power for the operation of
120 Volt AC, single phase, 60 Hz electrical, travel trailer
loads .
Circuit Breakers (AC) — The 120 Volt AC, 20A GFCI
duplex receptacles are provided with "push to reset" 20
Amp circuit breakers to protect the generator against
electrical overload .
4
120 Volt AC, 20 Amp
GFCI Duplex Receptacles
120 Volt AC, 30 Amp
Travel Trailer Receptacle
Main Breaker
CO Detection™ Carbon Monoxide (CO) Shutdown Indicator
Light — Indicates the engine shutdown due to carbon
monoxide accumulation around the generator or a CO
Detection system fault occurred .
Engine Switch — Set this switch to on (I) before starting
engine . Set switch to off (0) to shut off engine .
Low Oil Shutdown — This unit is equipped with a low oil
protection device . Oil must be at proper level for engine
to run . If the engine oil drops below a preset level, an oil
switch will stop the engine . Check oil level with dipstick .
Main Breaker — Protects generator against electrical
overload . If breaker trips, it cuts power to all receptacles .
Craftsman.com