Publicidad
Idiomas disponibles
Idiomas disponibles
Spray Technology
The spraying result depends crucially on how smooth and clean the surface before
spraying. Therefore, the surface must be pretreated and dust-free.
Not to be sprayed must be covered with tape and newspaper.
Cover screw or similar at the object being sprayed.
It is important to perform on cardboard or a similar surface spray sample to find the
right spray gun setting
FIG.8
FIG.6
FIG.7
Important: the open space of the spray area start and disruptions Avoid within the spray area.
Directional strength (Fig. 6) Hold the spray gun necessarily at equal distance of
about 5 -15 cm for the object being sprayed.
False (Fig. 7)
Tarke overspray, unevenly even surface quality.
Move the spray gun evenly across or up and down, depending on the pattern adjustment.
A uniform spray gun guide gives a uniform surface quality.
Clean as coating material buildup on the nozzle A and air cap B (Fig. 8) both parts
with solvents or water.
Work Stoppages
Decommissioning and cleaning
passes back into the container.
2 Unscrew the container. Remaining coating material in material tin back empty.
3 Containers and tubing with pre-cleaning brush.
Only use solvents with a flash point above 37.8ºC.
When a tube is not used, deposited solvent or water in addition to the container.
Therefore, the air is hoche ed current volume.
5 Repeat the above procedure is leaking at the nozzle clear solvent or water.
7 Then, empty the tank completely. Always keep container seal free of paint residue
and check for damage.
8 Clean spray gun and container exterior with a cloth soaked in solvent and water cloth.
9 Unscrew the nut, remove the air cap. Clean the air cap and nozzle with brush and
solvent or water.
Note:
Never clean the nozzle or air holes in the spray gun with sharp metal objects.
11
Publicidad
