Publicidad
Idiomas disponibles
Idiomas disponibles
To operate the self-propel system without blade rotation,
turn the self-propel speed-control knob on, press the
self-propel trigger(s).There are two self-propel triggers.
Press either trigger to start the self-propel function (Fig. O).
O-1 Self-Propel Speed-Con-
trol Knob
To turn the self-propel off, release the self-propel trigger,
turn the self-propel speed-control knob off.
MOWER-STATUS INDICATOR ON THE MOWER
(Fig. P)
The mower is equipped with a power indicator to indicate
the charge status of the battery pack and the working status
of the mower. The power indicator will illuminate when the
blade is rotating or when the LED headlights are turned on.
P-1
Mower-Status
Indicator
Mower-
status
Meaning
indicator
Mower is work-
ing properly;
Solid green
battery has at
least 15% of its
charge.
The side rails
are not fully
extended.
Flashing green
The handle is
not locked in
an operating
position.
Flashing red
Low battery.
The mower
Solid orange
stops due to
overheat.
Flashing
The mower is
orange
overloaded.
O-2 Self-Propel Trigger
P-2
Switch Button for
LED Headlights
Action
None required.
Stop the mower and
make sure that the side
rails are fully extended.
Stop the mower and
make sure that the
handle is locked in an
operating position.
Stop the mower and
charge the battery pack.
Remove the battery
from the mower, move
them to the shade and
cool them at least 15
minutes.
First remove the battery
pack, then check and
clean if grass has collect-
ed beneath the deck. Slow
down your pace when
cutting. If this does not
work, please contact EGO
customer service center.
56 VOLT LITHIUM-ION CORDLESS MOWER — LM2130E-SP
Flashing red/
green alter-
Error
nately
Battery over-
heat. (See sec-
Dark & LED
tion "BATTERY
HIGH-TEM-
on battery
PERATURE
flashing
PROTECTION"
in this manual)
MOWER OVERLOAD PROTECTION
To prevent overload conditions, do not try to remove too
much grass at one time. Slow down your cutting pace or
raise the cut height.
Your mower has built-in overload circuit protection. When
the mower is overloaded, the motor will stop and the
mower-status indicator on the mower will flash orange.
Remove the battery pack from the mower. Check to see
if grass has collected beneath the deck and clear it if
necessary, then install the battery and restart the mower.
BATTERY HIGH TEMPERATURE PROTECTION
The battery pack will generate heat during operation. The
heat dissipates more slowly in hot weather. If the battery
temperature exceeds 70°C during operation, the protection
circuit will immediately turn off the mower to protect the
battery pack from heat damage. The mower-status indicator
on the mower will off, please see 'BATTERY PROTECTION'
section in battery operator's manual. for details.
Release the bail switch, wait until the battery pack cools
down to approximately 67°C, then restart the mower.
MAINTENANCE
WARNING:
To avoid serious personal injury, always
remove the safety key from the mower before cleaning,
performing any maintenance or transporting the mower.
WARNING:
When servicing, use only identical
replacement parts. Use of any other parts may create a
hazard or cause product damage. To ensure safety and
reliability, all repairs and replacements should be performed
by a qualified service technician.
GENERAL MAINTENANCE
WARNING:
Always remove the safety key and battery
pack when servicing or transporting the mower.
The underside of mower deck should be cleaned after each
use, as grass clippings, leaves, dirt and other debris will
accumulate.
Remove any build-up of grass on or around the motor fan
(do not use water). Wipe the mower clean with a damp cloth.
Contact EGO customer
service center.
Release the bail switch,
wait until the battery
pack cools down to ap-
proximately 67°C, then
restart the mower.
9
EN
Publicidad
