GE AJCM 08 ACF Serie Manual De Instrucciones página 7

COOL MODE
Remote Control
1. Press COOL pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the
temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the COOL indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light
is lit for desired fan speed.
3. Press the
temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature. The
compressor will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a lower
number and the indoor air will become cooler.
HEAT MODE
Remote Control
1. Press HEAT pad.
2. Press LOW or HIGH pads to set desired fan speed.
3. Press the
temperature 60°F to 85°F in 1°F increments.
Control Panel
1. Press the MODE pad until the HEAT indicator light is lit.
2. Press the FAN pad until HIGH or LOW indicator light
is lit for desired fan speed.
3. Press the
desired temperature 60°F to 85°F in 1°F increments.
A thermostat is used to maintain the room temperature. The
heater will cycle on and off to keep the room
at the set level of comfort. Set the thermostat at a higher
number and the indoor air will become warmer.
FAN
Use the FAN to provide air circulation and filtering without
cooling or heating. Since fan only settings do not provide
cooling or heating, a temperature setting will not be displayed.
Set the thermostat at a higher number and the indoor air will
become warmer.
NOTE: If the air conditioner is off and is then turned on while set
to COOL, it will take approximately 3 minutes
for the compressor to start and cooling to begin.
pads to set the desired
Cooling Descriptions
with a middle set temperature.
and HIGH fan with a lower set temperature.
pads to set the desired
and LOW fan with a middle set temperature.
NOTE: There will be a 3-minute delay between setting
changes such as COOL to OFF and back to COOL.
Set the thermostat at a lower number and the indoor air will
become cooler.
NOTE: If the air conditioner is off and is then turned on while set
to HEAT, it will take approximately 1 minute
for the heater to start and heating to begin.
pads to set the desired
Heating Descriptions
with a middle set temperature.
and HIGH fan with a higher set temperature.
pads to set the
and LOW fan with a middle set temperature.
Remote Control
Press FAN pad. Press LOW or HIGH pads to set desired fan
speed.
Control Panel
Press the MODE pad until the FAN indicator light is lit
and the LOW or HIGH indicator light is lit for the desired fan
speed.
GEAppliances.com
Select the COOL mode and HIGH fan
Select the COOL mode
Select the COOL mode
Select the Heat mode and HIGH fan
Select the HEAT mode
Select the HEAT mode
7