Stihl MS 261 C-Q Manual De Instrucciones página 35

In the event of engine running problems,
first check that conditions for use of the
cover plate still apply.
Fitting the cover plate
Place the cover plate (1) in position,
N
engage the two tabs (arrows), and
secure it with the screws (2).
MS 261 C-Q
Starting / Stopping the
Engine
Positions of Master Control lever
STOP
0
Stop 0 – engine off – the ignition is
switched off.
Normal run position F – engine runs or
can fire.
Starting throttle n – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position as soon as the throttle trigger is
squeezed.
Choke shutter closed l – this position
is used to start a cold engine.
Setting the Master Control lever
To move the Master Control lever from
the normal run position (F) to choke
closed (l), press down the throttle
trigger lockout and squeeze the throttle
trigger at the same time and hold them in
that position – now set the Master
Control lever.
To select the starting throttle
position (n), move the Master Control
lever to choke closed (l) first, then
push it into the starting throttle
position (n).
The Master Control lever must be in the
choke closed position (l) before it can
be moved to the starting throttle
position (n).
The Master Control lever moves from
the starting throttle position (n) to the
normal run position (F) when you press
down the throttle trigger lockout and blip
the throttle trigger at the same time.
To switch off the engine, move the
Master Control lever to Stop 0.
Choke shutter closed (l)
If the engine is cold
–
If the engine stalls when you open
–
the throttle after starting.
If the fuel tank was run until empty
–
(engine stopped).
Starting throttle position (n)
If the engine is warm, i.e. if it has
–
been running for about one minute.
When the engine begins to fire.
–
After clearing a flooded combustion
–
chamber.
English
33