Publicidad
Idiomas disponibles
Idiomas disponibles
®
USING YOUR CHEF'SCHOICE
GOOSENECK KETTLE
Read all instructions carefully and take a minute to familiarize yourself with the user-
friendly controls of the Kettle (Figures 1 and 2) before using it for the first time. As with
any new kettle, do not use water from the first use or boiling; discard it and rinse the
inside of the kettle thoroughly with fresh cool water.
The appliance has three parts: the Kettle body, cover and the power base unit with
power cord.
The kettle can only be used with the power base provided. Base unit and Kettle must
bear the same model identification number. Unwind the power cord from the bottom
of power base to the desired length before plugging the cord into a powered outlet.
For your safety, this appliance plugs into a grounded 110-120 volt AC electrical outlet.
Do not attempt to defeat this feature by using a three-prong to two-prong adapter.
If your receptacle is only a two-prong type without a ground, seek help from a
licensed electrician.
A short power supply cord is provided with this appliance to reduce the risk of
someone becoming entangled in or tripping over a longer cord and causing the Kettle
to overturn, discharging its hot contents.
While The Legacy Companies does not recommend it, extension cords are available
and may be used if care is exercised in their use. If an extension cord is used it should
be a grounded three conductor cord with a matching plug configuration and rated at
not less than 15 amperes. If a longer cord is used it should be arranged so it will not
drape over counters or tabletops where it can be pulled, tugged on, or tripped over by
persons or pets.
The kettle lid must be fully closed when heating water. It is equipped with cover locks
so the cover remains on while pouring. To close the lid, press down firmly.
Fill the kettle with at least 16 ounces of water (which is approximately the same as
0.5 liter) and place the kettle on the power base. Do not fill the Kettle above the MAX
(maximum) line in the kettle to prevent water from splashing out through the spout
during boiling. For greatest accuracy and convenience, we recommend you fill the
Kettle with 1 quart of water.
If over filled and water flows down outside of kettle and on to its bottom of the power
base, unplug the power base unit, empty kettle and dry thoroughly. Refill before
returning kettle to the power base.
Whenever the power base cord is plugged into a 120V outlet and the kettle is placed
on the base the temperature measuring circuits are active. However, the heater will not
start until the power button is pressed and the LED lamp is illuminated. When the light
is on, the kettle will remain in a keep warm cycle for up to 120 minutes, unless
the kettle is removed from its base, a low water level is detected, or the "power"
button is pressed.
English — 5
Publicidad
