Fellowes LX Serie Manual De Instrucciones página 3

BASIC SHREDDING OPERATION
Continuous operation:
Up to 6-minute maximum
NOTE: Shredder runs briefly after each pass to
clear entry. Continuous operation beyond 6-minutes
will trigger 20-minute cool down period.
ADvANCED PRODUCT FEATURES
SAFESENSE
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
2
1
Touch test area and
Set to Auto-On ( ) to
look for the SafeSense
activate SafeSense
®
indicator to illuminate
PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator will remain illuminated
and the shredder will not operate for the duration of the recovery time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1 2
Set to Reverse ( )
Alternate slowly back and forth
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of
defects in material and workmanship and provides service and support for 2 years from the date of
purchase by the original consumer. Fellowes warrants the cutting blades of the machine to be free
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
remedy will be repair or replacement, at Fellowes' option and expense, of the defective part. This
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or
unauthorized repair. Fellowes reserves the right to charge the consumers for any additional costs
Australia Residents Only:
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and for compensation for any other
reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
The benefits under Fellowes' Warranty are in addition to other rights and remedies under a law in relation to the shredder.
PAPER/CARD
1
2
Plug in and put
Set to Auto-On (
disconnect power
switch in ON (I) position
TECHNOLOGY
®
3
SafeSense is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off ( )
3 4
Set to Off ( )
and unplug
3
) Feed paper/card
straight into paper
entry and release
2 3
*Apply oil across entry
Set to Reverse (
for 2-3 seconds
15
6
5
Gently pull uncut paper
Set to Auto-On (
from paper entry. Plug in. and resume shredding
incurred by Fellowes to provide parts or services outside of the country where the shredder is initially
sold by an authorized reseller. ANY IMPLIED WARRANTY, INCLUDING THAT OF MERCHANTABILITY
OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN DURATION TO THE APPROPRIATE
WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for any consequential
or incidental damages attributable to this product. This warranty gives you specific legal rights.
The duration, terms, and conditions of this warranty are valid worldwide, except where different
limitations, restrictions, or conditions may be required by local law. For more details or to obtain
service under this warranty, please contact us or your dealer.
4
When finished shredding
set to OFF ( )
)
)
3