Mark BEAM 198 MKII Manual página 12

16 CH mode 20 CH mode
5
6
7
8
9
10
11
12
13
14
15
16
TROUBLESHOOTING
This short guide is meant to help and try to solve simple problems, if they continue and the device
cannot operate, please, don't try to repair it by yourself, return the device to your MARK dealer.
No Light -The power supply.
1- Check that the unit is plugged into an appropriate power supply.
2- Check if the fuse is not blown, if it is, change it with one that keeps the same technical features.
If once the fuse is ok the device again blown it, please, don't change it again, contact the MARK
technical service.
3- If you are unable to determine the cause of the problem, do not open the device, as this may
damage the unit and the warranty will become void.
4- Return the device to your MARK dealer.
No DMX - Response: Verify that the DMX connection cable is correctly inserted in the device, verify
that the cable itself is not defective, or that the controller is operating correctly.
1- Check the DMX setting. Make sure that DMX addresses are correct.
2- Check the DMX cable: Unplug the unit; change the DMX cable; then reconnect to electrical
power. Try your DMX control again.
Function
5 PRISM
PRISM
6
ROTATION
7 COLOR HALO
8 FROST
9 FOCUS
10 PAN
11 PAN FINE
12 TILT
13 TILT FINE
14 NOT USED
15 RESET
16 LAMP
17 PAN/TILT SPEED
COLOR WHEEL
18
SPEED
19 FOCUS SPEED
20 GOBO SPEED
Value Explanation
231-236 Slow to fast gobo 13 shaking
237-243 Slow to fast gobo 14 shaking
244-249 Slow to fast gobo 15 shaking
250-255 Slow to fast gobo 16 shaking
0-127 On
128-192 Prism 1
193 - 255 Prism 2
0 No rotation
1-127 From fast to slow forward rotation
128-255 From slow to fast backward rotation
0-127 NO COLOR
128-255 Halo of color
0-255 0-100% insert frost
0-255 From far to closed
0-255 Pan 0-540º
0-255 Pan Fine
0-255 Tilt 0-270º
0-255 Tilt fine
0-127 off
128-255 3 seconds reset
0-25 off
26-100 3seconds lamp off
101-255 3 seconds lamp on
0-255 Fast to slow
0-255 Fast To slow
0-255 Fast to slow
0-255 Fast to slow
11