Publicidad
Idiomas disponibles
Idiomas disponibles
Top cutting
WARNING: If any parts are miss-
ing, damaged or broken, do not
operate your hedge trimmer until all
damaged parts have been replaced or
repaired. Failure to do so could result
in serious personal injury. DO NOT USE
WITHOUT FRONT HANDLE AND SAFETY
GUARD.
Side cutting
WARNING: Stop operating the trimmer
before rotating the handle.
Lubricating the cutting blade
NOTE : It is important to use only the
recommended standard lubricating
oil (WD-40) to avoid damage to the
blade.
To store your hedge trimmer
5. HOW TO USE YOUR HEDGE
TRIMMER
Before cutting an area, inspect it first and remove
any foreign objects that could become thrown or
entangled in the blades. Always hold the trimmer
with both hands and with the blade away from you
before turning it on.
When trimming new growth, use a wide sweeping
action so that the stems are fed directly into the
blade.
Allow the cutting blades to reach full speed before
cutting. When operating, keep the cutting blades
away from people and objects such as walls, large
stones, trees, vehicles, etc.
If the blade stalls, immediately stop the trimmer.
Release the two Switch Levers before attempting to
clear jammed debris from the cutting blades.
Wear gloves when trimming thorny or prickly growth.
Do not attempt to cut stems that are too thick for the
cutting blade.
Top cutting
Use a wide sweeping motion A slight downward tilt
of the cutting blades in the direction of motion gives
the best cutting results.
Side cutting
When trimming the sides of the hedge, begin at the
bottom and cut upwards, tapering the hedge inward
at the top. This shape will expose more of the hedge,
resulting in a more uniformed growth
Cordless Hedge Trimmer
6. MAINTENANCE
Remove the battery from Hedge trimmer before
carrying out any adjustment, servicing or
maintenance.
See Fig. H
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust.
See Fig. I1, I2
See Fig. J
See Fig. K
11
EN
Publicidad
