Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
:
The ECO program is suitable to clean normally soiled tableware, that
for this use, it is the most efficient program in terms of its combined
(*EN60436)
energy and water consumption, and it is used to assess compliance
with the EU ecodesign legislation.
Starting A
1. Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one.
2. Pour in the detergent.
3. Insert the plug into the socket. The power supply refer to last page "Product fiche".
Make sure that the water supply is turned on to full pressure.
4. Close the door, press the Power button, to switch on the machine.
5. Choose a program, the response light will turn on. Then press the Start/Pause
button, the dishwasher will start its cycle.
Changing The Program Mid-cycle
A program can only be changed if it has been running only for a short period of
time, otherwise the detergent may have already been released or the the wash
water with detergent has already been drained. If this is the case, the dishwasher
needs to be reset and the detergent dispenser must be refilled.
dishwasher, follow the instructions below:
1. Open the door a little to stop the dishwasher, after the spray arm
working, you can open the door completely.
2. Press Program button more than three seconds the machine will be in
program selection mode
3. You can change the program to the desired cycle setting.
3 sec
Program
.
14
To reset the
stopped
Publicidad
