identités 852012 Manual De Instrucciones página 18

Battery charging procedure
When you hear a beep, turn Off the emergency stop button and connect the control box. When the battery is fully charged,
the battery charge status shows 4 dashes (100%) and the LED on the control panel does not flash.
USE
1. Lifting the patient
• First, set the ride base in the maximum enlarged position. To do this, press the pedal Of the head adjusting the width of
the transport lifting device.
• For easy and comfortable lifting Of the patient should be prepared a transporter lifting device, a sling with a leg separa-
tor, a sling with head stabilization and a wheelchair.
• The patient should lie in the middle of the bed, then turn he/she to the side, in the opposite direction to the caregiver.
• The sling should be placed under the patient.Examples Of slings are shown in the figures 12 & 13.
• Turn the patient towards the caregiver and place he/she in the middle Of the sling so that the back loops are in the
upper back of the patient and the thigh loops be placed within the patient's thighs.
• Hanging loops should be hung on a four-point cradle.
• Make sure hanging loops are tight and make sure the patient is in a comfortable position.
• Lock the rear wheel brakes and lift the patient by pressing the corresponding button on the remote control.
• Should lift the patient until his feet are not touching the bed or the floor.
• Then unlock the rear wheel brake and carry the patient over the wheelchair.
• The brakes should be locked both in the transport lifting device and in the wheelchair.
• The next step is to press the "down" button on the remote control to gradually lower the patient.
• When descending, help the patient to take a correct and a comfortable sitting position.
• After setting down the patient in a wheelchair, remove the sling loops from the fourpoint cradle.
• If using a sling with a leg separator, make sure that the patient is properly dressed before moving the lift towards the
movable toilet chair.
• Make sure that the hanging loops are tight and that the patient is in a comfortable position.The patient can be placed
on the sling in a sitting position, e.g. when transported from a wheelchair or bed as follows.
• Place the sling around the back of the patient.
• Donning is easier if the patient bends slightly forward.
• Guide the sling carefully at the patient up on the height of the tailbone.
• Move the thigh belts forward at patient's thighs until they are on both sides at the same height.
• Be careful not to bend the material.
• Wear the seat belts under the patient's slightly parted legs.
• Donning is easier if the patient slightly raises thighs.
• In order for the patient to sit comfortably on a wheelchair, it should be planted as deep as possible.
• During the process, lowering the patient, lightly press the patient's knee so that his/her back is closest to the backrest
of the wheelchair.
• Loops have different colors to make it easier to put on slings at the same height.
Fig. 12. Sling with a leg separator
DMI-F-04_Annexe 3_Notice 1.0 RAJOUTER CODE ERREUR
Back loop
Thigh loop
Fig. 13. Sling with head stabilization
Back loop
Thigh loop
18