BYK byko-spectra Instrucciones De Uso página 11

Assembly
Step 3
Screw the four (4) 5/16" x 1" leveling feet into the
bottom of the side frames as shown above.
Step 4
Attach the luminaire to the upper framework by
aligning the slots on the sides of the luminaire with
the mounting studs in the upper portion or the
side frames and gently dropping the fixture into
place. The luminaire is correctly positioned when
the switchboard is located towards the front of the
unit (as shown to right).
Step 5
To attach the side walls, first, partially loosen
the screws holding the rear panels and viewing
surface in place. Insert each panel (making sure
that the folded channels are facing out and
forward) by sliding them between the side frames
and the viewing surface, at the bottom; the side
frames and the luminaire, at the top; and the side
frames and the rear panels, at the rear. When
installed correctly, the „V" notches in the side
panels will line up with the screws holding the rear
panels in place. Retighten the screws holding the
rear panels and viewing surface in place.
Note: There may be reasons to use the light booth
without side walls, such as viewing objects wider
than the booth.
11