Publicidad
Idiomas disponibles
Idiomas disponibles
REMOVING THE CAR SEAT FROM THE VEHICLE / REMOVING THE ISOFIX SYSTEM
Releasing the Top Tether: To release the Top Tether belt, press the button on the
Top Tether belt-tightening adjuster and loosen the belt to reduce the tension (fig. 21).
Unhook the belt anchoring carabiner. Push the car seat against the backrest of the
passenger seat (fig. 22).
At the same time press the ISOFIX release buttons and retract the ISOFIX connectors
(fig. 23).
Remove the car seat from the vehicle.
REMOVING THE HARNESS (Storing the safety harness away)
•
(Fig 24) - Completely loosen the shoulder straps, see paragraph "ADJUSTING THE
SEAT BELT (HARNESS) (From 76 cm to 105 cm)".
•
(Fig. 25) - Pull the handle on the headrest and, keeping it pulled, raise or lower the
headrest, adjusting it according to the child's height.
•
(Fig. 26) Press the red button on the central buckle to release the shoulder straps.
•
Unhook the press studs on the sides of the backrest fabric.
•
Lift up the seat cover fabric, pulling it out of the harness adjustment device and
lift up the inner padding, pulling it out of the harness adjustment device, pulling
carefully and gently.
•
Unthread the buckle inwards from the slots in the fabric and padding, open up the
container compartment door and put the buckle back inside (fig. 28).
•
Hook the tips to the buckle and insert the buckle into the internal compartment,
then close the compartment again (fig. 29, 30).
•
Reposition the internal padding correctly on the seat.
•
Put the fabric back onto the seat and backrest, then attach the press studs fig.31.
INSTALLATION IN THE FORWARD-FACING POSITION (Children between 100 and
150 cm in height, 3-point seat belt or ISOFIX + 3-point seat belt)
It is recommended that you use the 5-point harness for as long as possible. When the
growing child reaches a height of 100 cm, the car seat must be transformed for use
with children between 100 and 150 cm in height. In this configuration, it is necessary to
remove the 5-point seat belt (harness) supplied with the car seat.
See paragraph "REMOVING THE HARNESS (Storing the safety harness away)".
Only suitable for use in vehicles equipped with 3-point static or retractor seat belts,
approved according to regulation UN/ ECE no.16 or other equivalent standards.
As shown in figure 32, open the rear compartment door and insert the Top Tether belt.
Close the compartment.
• ENGLISH •
USE IN THE VEHICLE
42
Publicidad
