Foppapedretti Pitstop i-Size Manual De Instrucciones página 43

• ENGLISH •
USE IN THE VEHICLE
Modalità A - INSTALLING WITH 3-POINT SEAT BELT TOGETHER WITH ISOFIX
CONNECTORS
If your car does not have standard ISOFIX connector guides, insert those supplied with
the car seat with the recess facing upwards in the two ISOFIX anchoring points in the
car (fig 33).
☞ SUGGESTION: The ISOFIX anchoring points are located between the seat and the
backrest of the passenger seat.
Press both sides of the adjustment/release button on the ISOFIX connectors
simultaneously and extend the ISOFIX connectors ( (fig. 34).
Locate the ISOFIX attachments supplied with the vehicle.
Align the ISOFIX connectors with the anchoring points fixed to the vehicle passenger
seat and press until you hear a "click" (fig.35). The indicator on both brackets will turn
green, confirming that they have attached (fig.36).
Ensure that both brackets are correctly fastened. Shake the car seat to be sure it is
correctly fixed in place.
Push the car seat against the passenger seat, making sure that both ISOFIX connectors
are extended in the same position. There must not be any space between the backrest
of the passenger seat and the car seat (fig. 37).
Pass the diagonal part of the 3-point seat belt behind the headrest of the car seat and
through the green diagonal belt guide (A) located on the lower part of the headrest, on
the retractor side (fig. 38).
Place the child into the car seat (fig. 39). Press the button and raise or lower the headrest,
adjusting it according to the child's height (fig. 40). Make sure that it is correctly locked
in the chosen position (see par. "Headrest adjustment").
Pull out the 3-point seat belt of the vehicle and, passing it over the front of your child,
attach the vehicle's seat belt by inserting the tip into the buckle (B). A "click" will
indicate that it is attached correctly (fig. 41).
WARNING! The vehicle's seat belt buckle must not be placed in the lower guide of the
lap belt passage. Insert the diagonal belt and the lap belt into the lower loop from the
side near the fastening buckle of the vehicle's seat belt (C) (fig. 41). Thread the lap belt
on the opposite side of the car seat into the lap belt loop (D) (fig. 41).
WARNING! The lap belt must run as low as possible over your baby's pelvis. Insert the
diagonal belt into the belt guide loop (A), making sure it is not twisted.
43