FDV 464 Manual De Instrucciones página 19

session.
ATTENTION: This machine is not intended for wet
surface sweeping. However, if you encounter a
slightly damp environment (moisture buildup on the
floor), it is required that you turn the vacuum fan
switch off to prevent filter damage. Machine damage
due to wet debris pickup is not covered under
warranty.
ATTENTION: If the sweeper is lying inactive for a
period longer then one month you must disconnect
the red and black battery clips.
If the sweeper is lying inactive for a period longer
then one week you should leave it connected to the
electrical outlet.
WASTE HOPPER EMPTYING AND
CLEANING:
Before proceeding in removing the hopper assure that
the machine is turned off.
ATTENTION: WASTE DISPOSAL MUST BE DONE BY
FOLLOWING THE LAWS IN FORCE.
To clean the waste hopper proceed as follows:
- Release the hopper clamp by lifting and then pushing
on the back of the clamp.
- Pull out the hopper by its handle
-Empty the hopper
To put back the hopper proceed as follows:
- Slide the hopper back into place
- Lower and press the hopper clamp to lock into place.
Note: It is recommended to clean the pre-filter daily. See
cleaning and servicing the filter-page 7.
MACHINE MAINTENANCE:
All service performed should be completed by persons
who understand the machine or an AUTHORIZED
SERVICE CENTER. It is recommended that only
authorized repair parts be used for service.
FOR SAFETY: When servicing the machine
disconnect the battery connection and battery
charger plug before working on the machine
ENGLISH (Translation of original instructions)
MAINTENANCE CHECK LIST
The belts for slackening
The tightness of nuts and screws
The brushes for wear
The gaskets for wear and leakages
If all the functions are in working order
Empty hopper
Remove and shake pre-filter
Check main filter
SIDE BRUSH REPLACEMENT:
Raise the front part of the machine.
Press in the 2 tabs (indicated by the arrows) and pull off
the brushes.
Slide the new brush until it locks into place.
6
x
x
x
x
x x x x x x
x
x
x