Original Prusa MINI+ Manual De Instrucciones página 37

PASO 17 Uniendo las piezas - fase 3
Now, take the M3nE nut in the upper part of the extrusion and slide it under the
steel plate.
Make sure the hole in the nut matches the hole in the plate. Use the Allen key to
align it.
Fix both parts together using the M3x12 screw, tighten it slightly. DON'T tighten
the screw fully yet!
PASO 18 Alineando el ensamblaje XZ
In this step, you will move the entire XZ-axis, avoid pushing (grinding) it against the
aluminium extrusion, or you might scratch it. Leave a small gap while moving the
parts.
Rotate the back of the printer towards you.
Push the heatbed all the way to the "front".
Hold the Y-axis assembly.
Move the XZ-axis assembly to the back.
There is a notch, which indicates the correct mutual position of both parts.
Montando tu MINI+ (soporte bobina impreso)
Original Prusa MINI+ semi-montada 37