Original Prusa MINI+ Manual De Instrucciones página 39

PASO 21 LCD parts preparation
For the following steps, please prepare:
LCD assembly
M3x20 screw (1x)
Note there is a protective film on the screen, keep it on until the end of the
assembly to prevent scratches.
PASO 22 Mounting the LCD
First, carefully tilt the printer on its side. See the picture.
Place the LCD into the LCD holder. There is a notch, which fits inside the printed
part on the printer.
The design allows you to tilt the LCD into multiple positions. You can do it now or
later.
Use the M3x20 screw to connect both parts together.
Pro tip: if you find it difficult to tighten the screw, turn over the Allen key and insert
the short side of the key into the screw head. Tighten by the longer side of the key.
Montando tu MINI+ (soporte bobina impreso)
Original Prusa MINI+ semi-montada 39