Futurelight PRH-360 Pro-Rotating-Holder Manual Del Usuario página 39

- Auto scenes rec
With this function you can automatically record new scenes.
• Select "REC" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows"RE-XX", "X" stands for the total amount of memorizable scenes,
you can call up in "RUN". For example if the "XX" is 05, it means that "RUN" will run the first 5 scenes you
saved in "EDIT".
• Press [MODE/ENTER] to save and exit.
and save a maximum of 48 scenes.
• Press [EXIT] to exit. The number of steps can be defined under "STEP" and the scenes can be called up
under "RUN"
b) Editing via the external controller
• Call up the first scene in your controller now.
• Select "SC01" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "SC01".
• Press [MODE/ENTER], the display shows "C-01".
• Select "CNIN" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "OFF".
• Press [UP], the display shows "ON".
• Press [MODE/ENTER], the display shows "SC02". You successfully downloaded the first scene.
• Adjust the Step-time as described above.
• Call up the second scene in your controller now.
• Repeat steps 5-11 until all desired scenes are downloaded.
• Press [EXIT] to exit. The number of steps can be defined under "STEP" and the scenes can be called up
under "RUN"
- Editing the channels of the individual scenes
With this function you can edit the program to be called up in
Run.
a) Editing via the Control Board
• Select "SC01" by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "SCXX", "X"
stands for the scene no. to be edited.
• Change the scene no. by pressing [UP] or [DN].
• Press [MODE/ENTER], the display shows "C-XX", "XX"
stands for the channel no. Such as "C-01", it means you are
editing channel 1 of the selected scene.
• Select the channel no. you would like to edit by pressing [UP].
• Press [MODE/ENTER] to enter editing for the selected
channel , the fixture reacts to your settings. The display shows
the DMX value of the edited channel. Such as " 11XX", it
stands for channel 11 of the current scene, the DMX value is
XX , XX is a hexadecimal number value "01-FF".
• Adjust the desired DMX value by pressing [UP] or [DN].
• Press [MODE/ENTER] in order to edit other channels of this
scene.
• Repeat above steps until you finish setting all the DMX values
for all channels of this scene.
• Once all the channels completed, the display will flash
"TIME".
• Press [MODE/ENTER] to edit the time needed, the display
shows "TXXX","X" stands for the time needed to run the current
scene, value "001-999". For example, "T002" means you need
0.4 seconds to run the current scene.
• Adjust the desired time by pressing [UP] or [DN].
• Press [MODE/ENTER] to save the settings for the scene you
are editing, the display will change to the next scene
automatically.
• Repeat above steps to edit and other scenes, you can edit
39/79 00024219.DOC, Version 1.2