Publicidad
Idiomas disponibles
Idiomas disponibles
Dia 8
Angular Cutting
T
he angle adjustment
screw has combined with the lever. To adjust
the angle of inclination, loosen the angle
adjustment screw by turning the lever
anticlockwise. See dia 9.
Dia 9
You will then be able to rotate the base plate to
the required angle 0~ 45 to the left or right.
Angle of inclination numbers are stamped onto
the fan shaped bracket on back of the base plate
to help you set the correct angle. Check the
support roller before tightening. Firmly tighten
the angle adjustment screw by turning the
lever clockwise for operation. See dia10
Back of Jig saw
Disengage and set the lever to touch the
saw body, or the lever will hit the workpiece.
O
Dia 10
Note: To achieve a sufficient looseness or a
good tight fit of the base plate, you may need to
turn the lever repeatedly when loosening/
tightening the angle adjustment screw. The
lever has an engagement/disengagement system.
Pull the lever backwards to disengage whilst
the lever is turned to the leftmost or
rightmost position, and then reverse the lever,
further tighten/loosen the screw as necessary,
see dia 11.
Dia 11
9
Publicidad
