Publicidad
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
1. If your jig saw will not operate, check the fuse
and the power at the mains plug.
2. If the jig saw is not cutting properly check the
blade and support roller, replace blade if worn.
Also check the cutting angle, the blade must
be at exactly 90
o
use.
3. If a fault can not be found return the saw to an
authorised dealer for repair.
4. There are no user serviceable parts in the
jig saw.
Maintenance of the Jig saw
1. Clean the jig saw regularly(remove chips and bits
of wood etc.). For the best results do this straight after
the work has been completed.
2. Do not allow liquids to get inside the jig saw. Use a soft
cloth for cleaning the housing. Do not use petrol, solvents
or cleaners that may attack the plastic.
3. Air vents must always be clear and clean.
Advice on working methods, tips
1. Here is some advice on the pendulum action control:
the saw blade is only pressed against the material on the
return stroke/working stroke. It is moved away from the
material on the forward stroke. The result is better removal
of chips, less friction and therefore a higher output.
2. To avoid the jig saw springing up and down when
sawing sheets, support the sheet on timbers. When
sawing metal, apply a coolant oil along the cutting line.
3. Adjust the speed and the pendulum action settings
to suit the material to be sawn. We always recommend
that you carry out a test cut first.
4. To use the jig saw put the front end of the base plate on
the material and turn the machine on. Press the machine
from above on to the material and guide the jig saw along
the cutting line.
5. Do not use too much pressure to achieve the best
progress when sawing, use light pressure on the saw
blade.
6. When sawing along a marked line use the marking on
the splitting guard as a guide.
7. For exact cutting, clamp a timber batten on to the
material as an aid or use the parallel guide.
8. For mitres/bevels, set the base plate in the required
position.
9. Set the base plate to its rearmost position for cutting
close to an edge.
to the base plate for normal
10
Publicidad
