Felisatti DI13/650E Instrucciones De Servicio página 5

Impact Drill
Rated voltage
Frequency
Rated power
No load speed
Impact rate
Work shaft thread
Max. steel capacity
Max. wood capacity
Chuck clamping range
Weight according EPTA-Procedure 01/2003
Read the operating instructions
Protection category II power tool; double
insulated
In accordance with essential applicable safety
standards of European directives
In accordance with essential applicable safety
standards of Russian Federation
Wear eye, ear and breath protection
The instructions contained in this manual must be
strictly followed, it should be carefully read and kept close
at hand to use when carrying out maintenance on the
indicated parts.
If the machine is used carefully and normal
maintenance is carried out, it will work well for a long time.
The functions and use of the tool you have bought
shall be only those described in this manual. Any other
use of the tool is strictly forbidden.
ILLUSTRATIONS
DESCRIPTION (See figures)
A Drill chuck key (Fig.2)
B "Drilling/Impact Drilling" selector switch (Fig.1)
C Drill chuck shaft gap (Fig.1)
D Machine neck (Fig.2)
E Supply cord (Fig.1)
F Thumbwheel for speed preselection (Fig.1)
G Belt clip (Fig.1)
H Auxiliary grip (Fig.1)
I Rotational direction switch (Fig.1)
J On-/off switch (Fig.1)
K Retainer button (Fig.1)
L Key type drill chuck (Fig.2)
EQUIPMENT
- Auxiliary handle
- Depth gauge
- Drill chuck key
TECHNICAL DATA
-- Operating instructions with Safety instructions
- Warranty
The machine is intended for impact drilling in brick,
concrete and stone as well as for drilling in wood, metal
and plastic. Machines with electronic control and right/
left rotation are also suitable for screwdriving and thread-
cutting. Any other use not mentioned is not allowed.
Additional drill characteristics
- The rotational direction switch I is used to reverse the
rotational direction of the machine. However, this is not
possible with the On/Off switch J actuated.
- Electronic control of spindle speed, infinitely variable
by finger pressure on the On/off switch J.
The electronic regulation built-in the switch trigger F
-
allows to adjust the speed suitable for the material to be
worked.
- For continuous operation the On-/Off switch can be
locked in the "On" position by the button K.
BEFORE USING THIS TOOL
WARNING! Before carrying out any work, check, for
instance, using a metal detector, that there are no electric
wires or gas or water pipes under the surfaces you wish to
work on.
Make sure the mains voltage is correct: it must be
the same as that on the specification label. Machines with
230V can also be connected to a 220V mains supply.
To turn the machine on, press the ON/OFF switch J
and keep it pressed down.
When the ON/OFF switch is released, the machine
stops.
WARNING! Always disconnect the plug from the
socket before doing any work on the machine.
1. Changing the Tool
WARNING! Before any work on the machine itself,
pull the mains plug.
WARNING! Wear protective gloves when changing
the tool. The drill chuck can become very hot during longer
work periods.
Open the key type drill chuck L by turning until the tool
can be inserted. Insert the tool. Insert the chuck key A into
the corresponding holes of the key type drill chuck L and
clamp the tool uniformly.
2. Mains connection
WARNING! Connect only to a single-phase AC
W
min
-1
min
-1
mm
mm
mm
kg
BRIEF DESCRIPTION
DI13/650E
230
50-60
650
0-2800
0-44800
1/2''x20UNF
13
30
1.5-13
1.97
5