Kreg Crown-Pro Manual Del Usuario página 3

Assembly
B
Step 1.
and secure them in place using the two matching nuts.
A Base:
Add the 10 included rubber feet to the base for a solid
hold on your work surface
B
Height Extenders:
Dual adjustable arms extend upward to compensate
for extra wide moldings.
C
Spring Scale:
Loosen the black plastic nut and use the Spring Scale
to set your Crown-Pro™ to the correct spring angle.
D
Angle Finder:
Measures wall angle and spring angle
for proper tool and saw settings.
800-447-8638
A
Slide Guide
Step 2.
Connect the Molding Platform to the Base with
the large bolt. Place the Slide Guide over the
bolt (as shown) and secure it in place with the
plastic thumb nut.
Step 3.
Use the two small screws to secure the Spring
Scale to the Base. The screws will set fully
after only about one and a half turns of your
screwdriver. Do not over tighten.
Assembly
C
www.kregtool.com