DeFelsko PosiTest CH Manual De Instrucciones página 3

Preparing the PosiTest CH Cross Hatch Tester:
The cutting blade should be inspected before each use for signs of
wear or damage.
If the cutting edge is damaged or dulled, a new cutting edge should be
used. Each PosiTest CH Adhesion Tester Blade features 4 cutting
edges, 2 on each side.
NOTE:
If all 4 cutting edges have been damaged or dulled, the blade
should be replaced.
To install, rotate, or replace the blade follow these steps:
1. Remove the hex screw from the tool head using the included 3/32"
hex wrench.
2. To install a new blade, align the hole in the blade with the hole in the
tool head. To replace a cutting edge-carefully remove the current
blade and rotate or flip to another cutting edge on the same blade,
or replace with a new blade.
3. Insert the hex screw through the hole in the blade and turn
clockwise, using the included hex wrench, until the blade is
secured.
Each PosiTest CH Adhesion
Tester Blade features 4
cutting edges, 2 on each side.
4 Cutting Edges
2