Makita EN424MP Manual De Instrucciones página 12

Grease lubrication
Interval of lubrication: Every 50 operating hours
1. Remove the shear blades from the attachment.
2. Apply grease to the inner periphery of the holes
on the shear blades (Approximately 1.5 g (0.05 oz) as a
guide).
Fig.30
► 1 . Hole
3.
Install the shear blades to the attachment.
Grinding the shear blades
NOTICE:
If the shear blades have considerably
deformed by grinding, replace the shear blades
with new ones.
1. Install the battery cartridge to the tool.
2. Turn on and start the tool so that the upper blade
and lower blade are positioned alternately.
Fig.31
3. Turn off the tool and remove the battery cartridge
from the tool.
4.
Set the angle of a file to 45°, and grind the upper
blade from 3 directions with the file.
1
Fig.32
► ( 1) File (2) 45°
CAUTION:
make sure that the tool is switched off and the
battery cartridge is removed from the tool.
5. Place the tool upside down, and then remove the
burrs from the shear blades with the dressing stone.
Fig.33
► 1 . Dressing stone
6.
Set the angle of the file to 45°, and grind the lower
blade from 3 directions with the file.
7. Return the tool to normal position, and then
remove the burrs from the shear blades with the dress-
ing stone.
12 ENGLISH
1
2
Before grinding the shear blades,
1