Symbols; Features; Product Specifications - RIDGID R8481 Manual Del Operador

SYMBOLS

The following signal words and meanings are intended to explain the levels of risk associated with this product.
SYMBOL SIGNAL
DANGER:
WARNING:
CAUTION:
NOTICE:
Some of the following symbols may be used on this product. Please study them and learn their meaning. Proper
interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL
Safety Alert
Read Operator's Manual
Eye Protection
Wet Conditions Alert
No Hands Symbol
Recycle Symbol
V Volts
Hz Hertz
min Minutes
Direct Current
n o
No Load Speed
.../min Per Minute

FEATURES

PRODUCT SPECIFICATIONS

No Load Speed .................................................14,300/min
Maximum Planing Width ....................................... 3-1/4 in.
MEANING
Indicates a hazardous situation, which, if not avoided, will result in death or
serious injury.
Indicates a hazardous situation, which, if not avoided, could result in death or
serious injury.
Indicates a hazardous situation, that, if not avoided, may result in minor or
moderate injury.
(Without Safety Alert Symbol) Indicates information considered important, but
not related to a potential injury (e.g. messages relating to property damage).
NAME
Indicates a potential personal injury hazard.
To reduce the risk of injury, user must read and understand
operator's manual before using this product.
Always wear eye protection with side shields marked to comply
with ANSI Z87.1.
Do not expose to rain or use in damp locations.
Failure to keep your hands away from the blade will result in serious
personal injury.
This product uses lithium-ion (Li-ion) batteries. Local, state or
federal laws may prohibit disposal of batteries in ordinary trash.
Consult your local waste authority for information regarding available
recycling and/or disposal options.
Voltage
Frequency (cycles per second)
Time
Type or a characteristic of current
Rotational speed, at no load
Revolutions, strokes, surface speed, orbits etc., per minute
4 – English
DESIGNATION/EXPLANATION
Maximum Planing Depth .........................................5/64 in.
Maximum Rabbet Depth ...........................................1/2 in.