Mounting The Setting Device; Mounting The Rail (Special Accessory) - Bosch ACC 100 Instrucciones De Funcionamiento

6.2

Mounting the setting device

The mirror is packed separately for safety reasons.
First, fit the mirror in the setting device.
¶
Press the tilting mechanism (Fig. 7, Pos. 1) and push the
mirror (Fig. 7, Pos. 2) into the opening downwards at
an angle.
1
Fig. 7: Fitting the mirror
1 Tilting device
2 Mirror
Robert Bosch GmbH
Assembly (once-only procedure) | ACC 100 | 21
6.3
!
Check that the supporting surface is sufficiently even
before mounting the rail.
¶
Secure the rail to the floor of the workshop using the
supplied hexagon screws and plugs.
!
When fixing the rail, ensure that plugs are inserted
straight in order to avoid subjecting the rail to tension.
Next, check the straightness of the rail in the following
2
way (see Fig. 8):
1. Place the alignment angle on the right-hand end of the rail.
2. Position the wheel laser on the rail before the right-
hand end.
3. Switch on the laser.
4. Align the wheel laser with the aid of a base, so that
the laser beam impacts on both sides of the rail on the
control angle's vertical slot.
5. Move the alignment angle along the rail and check that
the point of the laser beam remains visible to the right
and left of the slot in the angle along the entire length
of the rail. The maximum allowable deviation for the
straightness of the rail is 0.6 mm!
i
If the laser beam is no longer visible to the left or
right of the slot in the alignment angle, this indicates
that the straightness of the rail deviates beyond the
maximum allowable limit.
6. In the above case, please align the rail as necessary. To
do so, release the hexagon screw(s), then re-tighten the
rail and check once more with the alignment angle.
7. If, after this, the rail is still misaligned through exces-
sive tension, new holes must be drilled for the plugs.
i
Please mark the floor as appropriate to indicate the
area for the vehicle, in order to ensure the correct
distance from the rail. Bear in mind that the mirror
must be at a distance of 120 cm +/- 5 cm from the
front edge of the ACC sensor.

Mounting the rail (special accessory)

Never look directly at the source of the beam!
1 689 979 811
en
|
2017-12-12