Publicidad
Idiomas disponibles
Idiomas disponibles
Shield installation
1. Bracket.
2. Shaft tube.
6. Four bolts.
Insert the shield between the shaft tube and the bracket with a spacer.
Fit a spacer and the shield support on the shaft tube and tighten four bolts lightly.
Tighten the four bolts firmly.
7. Clog prevention plate.
Install the clog prevention plate with three screws.
Installing blade
The blade retaining nut equipped with this unit is a nylon lock nut that provides addi-
tional resistance to loosening. Always use a new nylon lock nut when replacing the
blade or when the nylon or the nut becomes worn or damaged. Only use genuine
ECHO nylon lock nuts as replacement parts when servicing this unit.
Fasten output shaft using locking tool securely in order to avoid the possibility of
output shaft rotating when mounting cutting blade which will prevent the cutting
blade fastening nut from being tightened sufficiently.
Wear gloves to reduce the risk of injury caused by unintentional contact with the
blade.
NOTE
Check to be sure the locking tool is fully engaged to prevent the output shaft from turning.
Inspect blades before installation.
Check for sharpness.
Dull blades increase the risk of blade kickback reactions.
Small cracks can develop into fractures resulting in a piece of blade flying off during operation.
Discard cracked blades no matter how small the crack.
1. Blade retainer.
2. Blade retainer fixing slot.
4. Lower blade retainer.
Remove nut, cup and lower blade retainer.
Install blade retainer, blade, lower blade retainer, cup and nut finger tight.
7. Locking tool
Insert locking tool into a hole located on the right side of angle transmission while forcing
retainer spring to the left side.
Insert locking tool further into blade retainer fixing slot to fix output shaft.
8. Tightening direction.
Tighten the nut (turn anticlockwise) using a socket wrench.
Never fasten while applying your weight.
Otherwise the thread of nut could be broken.
Remove locking tool.
3. Shield.
4. Two spacers.
8. Three screws.
9. Locking tool hole.
DANGER
CAUTION
5. Cup.
6. Nut.
9. Socket wrench.
17
5. Shield support.
3. Blade.
Publicidad
