Before Connecting Components - Yamaha YSP-600 Manual De Instrucciones

Before connecting components

Cables used for connections
Audio/Video
A
HDMI cable
Audio
Audio pin cable (supplied)
(White)
(Red)
Optical cable (supplied)
Digital audio pin cable (supplied)
(Orange)
Subwoofer pin cable
5
System connector cable
Video
OSD video pin cable (supplied)
(Yellow)
Notes on connecting the optical cable
• Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put
the cap back in place.
• When inserting the cable into the optical digital jack,
make sure the direction is correct.
Cap
Information on HDMI™
Audio signals
Input source
DVD video
DVD audio
Blu-ray Disc
HD DVD
(White)
Notes
• When CPPM copy-protected DVD audio is played back, video and
(Red)
audio signals may not be output depending on the type of DVD player.
• This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
y
• We recommend that you use an HDMI cable shorter than 5 m
(16 ft) with the HDMI logo printed on it.
• Use a conversion cable (HDMI jack
this unit to other DVI components.
(Orange)
Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
order: HDMI → Digital → Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
Input
jack
Input
source
TV/STB
DVD
AUX
VCR
(Yellow)
Note
This unit is compatible with 2-channel PCM signals, but not with
multi-channel PCM signals.
Connections
Audio signal type
Dolby Digital, DTS, PCM
2-channel stereo
(up to 96 kHz/24 bit)
Dolby Digital, DTS, PCM
↔
DVI-D jack) to connect
HDMI Digital Analog
17
En