Descargar Imprimir esta página

DeWalt DCL079B Manual De Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

English
Important Safety
Instructions

WARNING!
light, basic precautions should always be followed,
including the following:
a ) Read all the instructions before using the tripod light.
b ) To reduce the risk of injury, close supervision is
necessary when a tripod light is used near children.
c ) Avoid contact with hot parts.
d ) Do not operate any tripod light after it has
received a sharp blow, malfunctions or is
dropped or damaged in any manner. Return
tripod light to the nearest authorized service
facility for examination, repair, or electrical or
mechanical adjustment.
e ) To reduce the risk of electrical shock, do not put
tripod light in water or other liquid. Do not place
or store tripod light where it can fall or be pulled into
a tub or sink.
f ) Only use attachments recommended or sold by
the manufacturer.
g ) Risk of electric shock. Do not expose to rain.
Store indoors.
h ) To reduce the risk of injury, do not stare at
operating lamp. Serious eye injury could occur.
SAVE THESE
INSTRUCTIONS
Specific Safety Rules for Tripod Lights

WARNING: Fire hazard. Do not operate tripod light
near flammable liquids or in gaseous or explosive
atmospheres. Internal sparks may ignite fumes
causing personal injury.
Do not submerge tripod light in any liquid.
The tripod light is intended for commercial and
household use.
Before using battery and tripod light, read all instructions
and cautionary markings on tripod light and battery pack.
This appliance is not intended for use by persons
(including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction
concerning use of the appliance by a person responsible
for their safety.
Store the tripod light indoors when not in use. Keep out of
reach of children.
DO NOT attempt to charge the battery pack with any
chargers other than the ones in this manual. The tripod
light and battery pack are specifically designed to
work together.
Place the tripod light away from any heat source.
Do not disassemble tripod light. Take it to an authorized
service center when service or repair is required. Incorrect
2
When using the tripod
reassembly may result in a risk of electric shock,
electrocution or fire.
The DCL079 tripod light is designed to operate on fully
charged D
WALT 20V Max* or FLEXVOLT™ lithium-ion
e
battery packs. Do not use any other voltage.
While transporting, be sure the light head is collapsed
to its lowest position, the extension poles are locked,
and the tripod's legs collapsed and locked into their
carrying position.

WARNING: To reduce the risk of fire, do not place
anything on top of the lens during or after operation
of the light.

WARNING: Do not place the tripod light in a
position which may cause anyone to intentionally or
unintentionally stare into the light head. Serious eye
injury could result.

CAUTION: Only use tripod light on stable surface.
Do not raise above work space/personnel via lifting,
hoisting, mounting, or suspension.
The label on your tripod light may include the following
symbols. The symbols and their definitions are as follows:
V ......................... volts
Hz ....................... hertz
min ..................... minutes
or DC ...... direct current
...................... Class I Construction
(grounded)
.../min .............. per minute
BPM .................... beats per minute
IPM ..................... impacts per minute
RPM .................... revolutions per
minute
sfpm ................... surface feet per
minute
SPM .................... strokes per minute
A ......................... amperes
W ........................ watts
or AC ........... alternating current
or AC/DC .... alternating or
direct current
Important Safety Instructions for the
Tripod Light

WARNING: Read all safety warnings and all
instructions for the battery pack and tripod
light. Failure to follow the warnings and
instructions may result in electric shock, fire and/
or serious injury.
The tripod light is intended for workspace lighting
only. Use as directed. Any other uses may result in risk of
fire, electric shock or electrocution.
Do not expose the tripod light to rain or snow.
When operating the tripod light outdoors, always
provide a dry location.

CAUTION: When not in use, place tripod light
on its side resting on the stand portion of the
handle/rest 
on a stable surface where it will
 5 
not cause a tripping or falling hazard.
...................... Class II
Construction
(double insulated)
n o ....................... no load speed
n ......................... rated speed
...................... earthing terminal
..................... safety alert symbol
..................... visible radiation
..................... wear respiratory
protection
..................... wear eye
protection
..................... wear hearing
protection
..................... read all
documentation
..................... hot surface
..................... on/off button
..................... pinch/crush hazard

Publicidad

loading

Este manual también es adecuado para:

Dcl079