camry Premium CR 2021 Manual De Uso página 4

15. WARNING: Do not use this equipment near bathtubs, showers, swimming pools or
similar bodies of water.
16. Do not allow the device or power adaptor to wet. If the device falls into water,
immediately remove the power plug or power adaptor from the socket. If the device is
powered, do not put hands in the water. Have the device checked by the qualified
electrician before using it again.
17. Do not touch the device with wet hands.
18. The device has to be turned off after every use.
19. Never leave the product connected to the power source without supervision. Even when
use is interrupted for a short time, turn it off from the network, unplug the power.
20. In order to provide additional protection, it is recommended to install residue current
device (RCD) in the power circuit, with residual current rating not more than 30 mA. Contact
professional electrician in this matter.
21. Do not use the device outdoors.
22. Do not direct the hot stream to the cord.
23. After using the device, each time turn it off with the switch and remove the plug from the
mains socket.
24. Do not wrap the cord around the appliance.
25. Attention!!! The device heats up during use. Do not touch the hot surfaces of the device.
26. Be sure that accessories are dry, before you attach it to hair dryer.
27. Never use sharp tool to clean the device.
28. Never direct hot air toward eyes and other sensitive parts.
PRODUCT DESCRIPTION
1 - housing
3 - switch On/Off/temperature adjustment
5 - swivel cord
7 – air filter
USING THE DEVICE
Hair styling with rotating brush. To rotate brush press one of the rotating brush buttons (6). You can rotate it left or right.
1. Attach brush (2) by putting it on the pin.
2. Move the brush lock slider (4) to lock.
3. Make sure that the brush is properly attached and does not slip off the pin.
4. Connect the plug to the power socket
5. Turn on hair styler with the switch (3). Adjust required air temperature (*- cool shot, 1 - lower temperature and speed, 2 - higher
temperature and speed)
NOTE: The cool shot blow is only for fixing the hairstyle, therefore the brush does not rotate when using this function.
4. Separate streak of hair, brush out, and start to wind from the end on the brush using rotating brush buttons (6). Wait few seconds till hot
air stream consolidate shape of winded hair.
5. Unwind hair.
6. Turn off the hair styler and unplug it from the power socket.
7. Form required hairstyle with brush or comb.
CLEANING AND MAINTENANCE
1. Unplug hair styler from the power socket before start cleaning.
2. Wipe outer housing (1) with damp cloth. Do not use abrasive or sharp materials.
3. Clean brush from hair after each use.
4. Check if the air inlet filter (7) is not stuck with hair or other dirt. If necessary clean it out.
5. Do not leave any hair on the hair styler.
2 - removable brushes
4 - brush lock slider
6 - rotating brush buttons (left / right)
8 – hook for hanging
4