Publicidad
Idiomas disponibles
Idiomas disponibles
The closure is difficult to
unscrew.
After refilling the water tank,
the light
does not reset.
All LEDs are flashing.
Steam icon is permanently on,
but there is no steam emission
from the soleplate.
Steam or water comes out
from the closure.
The double cord gets hot
during use.
Lime scale has made the closure
difficult to open.
The boiler is still under pressure.
The water float does not work
appropriately.
The water tank is not positioned
correctly.
System error.
Water tank float is locked or
the water tank is not correctly
inserted.
The closure is not tightened
properly.
This is normal. It is caused due
to the steam passing through the
cord during ironing.
Turn the cap forcefully. To avoid the
problem, rinse system frequently.
Never open the closure if the boiler
is still under pressure or hot. Wait at
least 2.5 hours before opening the
closure.
Empty the water tank, rinse out and
refill.
Position the water tank correctly.
Unplug the appliance, plug it in
again and press On/Off button. If
this problem is still present, turn the
appliance off immediately, unplug
and contact an authorised Braun
Customer Service.
Turn off and unplug the appliance.
Remove and empty the water tank,
rinse out and refill. Insert the water
tank.
Switch on the appliance and wait
until the device is ready to use.
Press the steam button and wait
until steam comes out.
Keep the steam button pressed for
10 seconds of steam emission then
release the steam button.
Switch off the appliance, unplug
and let it cool down (for at least
2,5 hours).
Unscrew the closure and screw it
back on the appliance properly.
Note: Some water can escape
when you unscrew the closure
Place the double cord on the
opposite side so that you cannot
touch the cord during ironing.
17
Publicidad
