Bimar DEU311 Manual De Instrucciones página 15

Fax +32 030 9904733

outlet, and check the free space front and rear is at least 50 cm. The bearing surface must be stable,
non-sloping to avoid the device tipping over or dripping water.
 Do not install the dehumidifier in environments where there are flammable products (gas, sulphur,
oil, etc.), or in a dusty environment.
 The surface where the device is used must be stable, spacious (do not use on shelves), and level
(since the device could tip over) and where it will not be knocked. Do not use the dehumidifier in
small areas and do not place anything on top of the air outlet grid since the lack of adequate
ventilation can cause overheating.
 Position the device:
- far from other heat sources (e.g. ovens, gas stoves
etc.), flammable materials (tapestries, etc.), explosive
materials (spray cans) and materials that can become
deformed with heat; ensure that there is at least 50cm
of free space around the device.
- liquid containers (e.g. bathtubs, showers, sinks etc.) to
avoid splashing water and to avoid it falling
(minimum 2 metres). Should it accidentally get wet
or fall into a liquid, first turn off the power outlet by
turning off
the main switch on the electrical panel, and only then remove the plug from the socket. Dry
thoroughly and check that the electrical parts are not wet; if in doubt consult a qualified professional.
 If there is a fault or the device is not working correctly, switch it off and have it checked by a
qualified professional. Repairs done by an unqualified person can be dangerous and cause the
guarantee to become void.
 The device does not require any installation work, i.e. pre-arrangement of electrical connections /
water / anchoring / or other for its use.
 In the event of transport, the device must remain in an upright position (for at least an hour);
obviously the tank must be completely empty and dry.
DESCRIPTION
The device is equipped with:
Main unit (1): with air outlet nozzle (2), air inlet grid (3), air filter (4), control panel (5), exhaust
nozzle for continuous tube (6), discharge spout cap (7), cable reel (8) or electric cable (9).
Description of Control Panel

Button "

Tank full light (
when the tank is not correctly inserted and the device will enter standby mode.
When the dehumidifier operates at low temperatures (12-15 °C), frost may build up on the evaporator
coils, the compressor will stop its cycle and the fan will continue running until the frost disappears. If
the dehumidifier is blocked, switch off the device and unplug it from the mains, and then turn it back
on. If the room temperature is below 5 °C, the dehumidifier will not work; the operating temperature
must be between 5-35 °C.
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar
(Italy). The pages must be reproduced and folded in
order to obtain a booklet A5 (+/- 148.5 mm width x 210
mm height). When folding, make sure you keep the good
numbering when you turn the pages of the I/B. Don't
change the page numbering. Keep the language
integrity.
" (A): Press to turn on or to put the device on standby.
): on full when the water has reached the maximum level or blinking quickly
Assembly page 15/51
15