Publicidad
Citroen_C4_Picasso
2.0
Fuse
Fuse
5A
15A
Relé
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Citroen C4 Picasso 1.6 16 V 121 kW 5G01 Euro 6B GPL
Multipoint Electronic Injection
Changeover Switch
Cut and
Insulate
Singularly
Gas Pressure
and
Temperature
Sensor
Gas
Inlet
Gas Injectors Sequence
Wiring diagram
Diagnostic
Point
Red
3
2
1
Black
Black
Black
Red
Red
+
Cut and
Insulate
Singularly
Pin n° 21 Conn. PP2
Pin n° 30 Conn. 120
Pin n° 73 Conn. 120
Pin n° 66 Conn. 120 (1° Injector Signal)
Pin n° 45 Conn. 120 (1° Injector Positive)
Pin n° 25 Conn. 120 (2° Injector Signal)
Pin n° 4 Conn. 120 (2° Injector Positive)
Pin n° 24 Conn. 120 (3° Injector Signal)
Pin n° 3 Conn. 120 (3° Injector Positive)
Pin n° 67 Conn. 120 (4° Injector Signal)
Pin n° 46 Conn. 120 (4° Injector Positive)
Sensor
temperature
water
DO NOT CONNECT
Petrol
Injectors
Sequence
7|7
Date:
Diagram n°:
In place of diagran n°:
Draftsman.:
Signature:
Level sensor connector
Cut and Insulate
Rear Solenoid Valve Connector
-
Battery
Warning: CAN BUS connection
can NOT be made on diagnostic
socket level, but it MUST be
made on petrol ECU connector level.
Compartnent
Engine
Fuse
Pin n° 33 Conn. 70
Box
Pin n° 49 Conn. 70
Petrol
ECU
MAP
MV
24_02_20
-
//.//.//
I.C.
fusibili
FSG000127R
Publicidad
