Description; Components; Monitor; Outdoor Station, Exterior Camera - Extel LOLA 4.2 Instrucciones De Uso E Instalación

2. DESCRIPTION

1 •

Monitor

2 • Outdoor Unit
3 • Monitor wall carrier
4 • Adapter
Generality
This videophone consists of an interior unit with a colour, liquid crystal display screen, a free hand interphone, and
a surface-mount exterior outdoor station which makes it possible to see and speak to the visitor who as rung. To
make the most of the videophone, please take the time to read this instruction manual thoroughly, and do not
lose it.

3. COMPONENTS

a. Monitor
(fig 2a)
1. Control screen on which appears the visitor's face (9 cm - 3,5'')
2. Communication with the roadside panel.
3. Stopping the image
4. Microphone to communicate with the visitor.
5. «DOOR-OPENER» control: Press this key to open the door (if a closure system is installed).
6. Resuming the image
7. Terminal blocks for connecting wires.
8. Outlet for the 15 V
standards in force in France).
9. Speaker for ring tone and sound coming from the roadside panel.
b. Outdoor station, exterior camera
1. Auto focus C-MOS camera lens
2. Twilight cell.
3. Speaker: allows to be heard outside.
4. Name holder (illuminated after call)
5. Microphone: enables the visitor to communicate with the internal unit.
6. IR LED lighting*: enables seeing the visitor even in a low light environment (visitor at a distance lower than 30
cm. Beyond this distance, use an additional lighting). (* invisible to the naked eye)
7. Call button: when pressing this button, the internal units ring, the camera and the monitor start working.

4. INSTALLING

N.B. : If you try your product before installing it, please be sure not to do it with the roadside panel and the
monitor in the same room, otherwise the video door phone will produce a shrill sound
Before the installation :
(Removal procedure of the call button of the roadside panel to access the nameplate (fig.2b))
1. With a screwdriver, remove the camera block from the roadside panel (A)
2. Remove the call button block from the front panel with a light pressure on the side tabs (B)
3. With a screwdriver, unscrew the screw and separate the button from the nameplate block.
4. Remove the protective cover and write your name on the label.
5. Replace carefully the block in its original position.
(fig 1)
(fig 2)
plug of the adapter (adapter to connect to an installation compliant with NCF 15-100
(fig 2b)
(fig. 3-4)
CFI EXTEL - LOLA 4.2 - 07-2012
(Larsen effect)
GB2