S&P MP-EMIDUAL Instrucciones De Uso página 11

modify the programme: For each time you press the
"COMFORT" temperature is set, while for each time you press the
key, an hour of operation at the "ECO" temperature is set.
If, for example, you wish to set the "ECO" temperature from 00:00 to 06:00 and from
10:00 to 17:00, and the "COMFORT" temperature from 06:00 to 10:00 and from 17:00 to
24:00, you must proceed as follows:
At the end of the definition of the 24 hours of the day, or even in an intermediate phase
if the hours that remain to be defined are already correctly set, by
pressing you automatically move on to setting the programme for the following day
which, as a preset value, has the same programme as the day you have just finished set-
ting.
Please note: The programming process starts from the first day of the week, and for it to
be correctly set it is necessary to define all 7 days of the week.
Warning: As a cautionary measure, the "Off" status does not mean that the product is
entirely off, but that the antifreeze function has been activated. The display will show the
corresponding programme (P1 or P2) and the corresponding symbol "
During normal operation, when displaying programmes P1 or P2, the symbols "COM-
FORT" or "ECO" are shown on the display in relation to the setting of the temperature
set for the current time. The time, on the other hand, is shown by means of a flashing
rectangular bar at the bottom of the display.
4. DATA TRANSMISSION AND USE OF THE PRODUCT
After having set the time, the day, the temperatures and the desired operative program-
me, the remote control is ready for the transmission of data to the product.
WE WOULD LIKE TO REMIND YOU THAT THE TRANSMISSION OF THE TIMETABLE
AND THE TRANSMISSION OF THE OPERATIVE PROGRAMME ARE NOT SIMULTANE-
OUS, AND MUST TAKE PLACE BY MEANS OF TWO SEPARATE OPERATIONS.
Press the key to display the "CHRONO" mode or the programme (P1 or P2) that you
wish to send;
Aim the infrared transmitter on the remote control towards the receiver on the product
(located near the operative LED).
Hold the key down for at least 3" until the data transmission symbol appears on the
display and the product operation LED flashes five consecutive times.
00:00 06:00 10:00
7 x 4 x
key, an hour of operation at the
17:00
7 x 7 x
11
24:00
".