All operating elements and connections de -
GB
scribed can be found on page 2.
1 Operating Elements
and Connections
1.1 Rear side
1 Mounting brackets
2 Operational buttons
Buttons UP and DOWN for selection of a control
programme or a colour and for adjusting the
DMX start address
Button ENT (= Enter) to confirm a selection and
to memorize an adjustment
Button FUNC (= Function) to select the operat-
ing mode
DMX reception, control by other spot-
lights (slave mode) or remote control, adjust-
ment of the DMX start address
programmes running automatically
programmes controlled by music
colour spotlight with selectable colour
3 Display
4 Connection jack REMOTE for the foot-operated
remote control FS-2PARL (at option)
5 Microphone for music control
6 Control SENSITIVITY for the sensitivity of
response in case of music control via the micro-
phone (5)
7 Locking screws for the mounting brackets (1)
8 DMX signal input (3-pole XLR) for connection of
a light controller;
pin 1 = ground, 2 = DMX-, 3 = DMX+
9 Connection POWER LINK OUTPUT for power
supply of another unit
10 Mains jack for connection to a socket (230 V~/
50 Hz) via the supplied mains cable or for con-
nection to the jack POWER LINK OUTPUT (9)
of another PARL-102DMX
11 Lug for fixing a safety rope
12 Support for the mains fuse
Only replace a blown fuse by one of the same
type
13 DMX signal output (3-pole XLR) for connection
to the DMX input of another DMX light effect
unit;
pin 1 = ground, 2 = DMX-, 3 = DMX+
10
All manuals and user guides at all-guides.com
1.2 Remote control FS-2PARL
The remote control is available as an accessory
and is not supplied together with the light effect
unit.
14 Display
15 Button COLOUR to select a light colour
16 Button MODE to select a colour changing pro-
gramme or a stroboscope programme
17 Button BLACKOUT to switch the light on and off
18 Jack RJ45 for connection to the jack REMOTE
(4) via the supplied cable
19 Microphone for music control
20 Control SENSITIVITY for the sensitivity of
response in case of music control via the micro-
phone (19)
Note: For control via the remote control no DMX signal
must be present at the input DMX INPUT (8).
2 Safety Notes
The units (spotlight PARL-102DMX and remote
control FS-2PARL) correspond to all relevant direc-
tives of the EU and are therefore marked with
WARNING The spotlight uses hazardous mains
voltage. Leave servicing to skilled
personnel only and do not insert any-
thing into the air vents; inexpert han-
dling may result in electric shock.
Please observe the following items in any case:
G
The units are suitable for indoor use only. Protect
them against dripping water and splash water,
high air humidity, and heat (admissible ambient
temperature range 0 – 40 °C).
G
Do not place any vessels filled with liquid, e. g.
drinking glasses, on the units.
G
Do not set the spotlight into operation or immedi-
ately disconnect the mains plug from the mains
socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by skilled
personnel.
G
Never pull the mains cable for disconnecting the
mains plug from the mains socket, always seize
the plug.
G
No guarantee claims for the units and no liability
for any resulting personal damage or material
.