Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING!
Charging must be done in indoors, in a well ventilated area away from the sunlight, children,
heat and ignition sources.
Never use the charger if any damage is found.
Use the original the charger provided only.
Make sure cleaner and the charger are clean and dry before set up.
NOTE: Charge the cleaner 3 hours prior to the first use.
Normally cleaner can be operated for 30 minutes after fully charged.
Set Up for Operation
The arrow of transparent suction head part Handle assembly and transparent body should be
aligned, and then you can put down the transparent garbage can to the bottom of transparent
body. Then rotate 90 degrees rightly (from open to close).
Handle assembly
lnsert the handle as shown behind big department, according to needs, looking for what kind
of convenient way to clean the wall and bottom of the POOUSPA, you find easier to hold the
cleaner when cleaning the pool / spa wall and bottom. lnsert the handle into the cleaner as
shown until the side pin on the handle is secured in the Handle Locking Hole on the cleaner.
To ralease the handle, press down the side pin and pull out the handle.
Telescopic pole assembly
lnsert the end(with one side pin)of the Pole Connector into the cleaner as shown until its single
side pin is secured in the Hand Locking Hole of the cleaner. Slide and align the side holes of the
telescopic with the side pins of the Pole Connector.
To release the telescopic pole, press down two side simultaneously and pull out the pole.
4
Publicidad
