Chasing Grabber Arm 2 Manual Del Usuario página 3

CHASING Grabber Arm 2
EN
User Manual
V1.0
CHASING Grabber Arm 2 is a customized accessory for the Gladius series. Its
simple and easy tool replacement form and intelligent grip control system provide
more help for users to explore unknown underwater areas.
Installation and Use Instructions
1. Install the grabber claw on the ROV support
rod and fix it with four M3*8 screws.Plug one
end of the 4-pin double-headed connection
cable into the 4-pin port at the rear of the
grabber claw, and tighten it with hand. Then,
plug the other end of the connection cable
into the 4-pin port on the side of the ROV
(depth sensor), and tighten it with hand.
Camera
4-pin port
Tool Head Replacement
1.①Turn the right wave wheel on the right to open the original tool head to the
maximum, ②Remove the thumb screw, ③Remove the claw before you replace it.
03
1. Two-jaw clamp
2. Mounting port of the claw
3. Thumb screw
4. Grabber Arm 2
5. Port of the 4-pin connection cable
6. Mount holder of the Grabber Arm 2
2. Wait for the ROV to activate after turning on
before operating: Press and hold the grabber
claw button on the remote controller or enable
the grabber claw function in app settings,
and then use the right thumb wheel on the
remote controller to control the opening and
closing of the grabber claw.
中国移动 20： 37 89%
Control
Power Linear
The right impeller is cut into a robotic arm
Switch the right wave wheel roll control to robotic arm control
Right wave wheel
*Note: When there is no tool head installed on the grabber claw, if you need to
install a tool head, turn the right wave wheel to extend the middle shaft to the
front end, then install the tool head.
Specifications
Maximum Opening Of The Grabber Claw
Maximum Gripping Force
Main Body Weight
Two-jaw Clamp Weight
Maximum Diving Depth Supported
Dimensions Of Grabber Claw Body
Two-jaw Clamp Size
Notes
1) Before using the remote controller to control the grabber claw, press and hold
the button on the rear-right (with the grabber claw icon) or enable the grabber
claw function in app settings.
2) When installing the tool head of grabber claw, you need to extend the middle
shaft to the front end by using the remote controller before installing the claw.
3) Make sure the ROV is powered off before you install and connect ththe grabber
claw.
4) Check the ROV and make sure the ports are dry and clean before use. Salt and
moisture may corrode the port. If there are water droplets in the port, be sure to
flush the port with fresh water, and then use a paper towel or cotton ball to
absorb the water in the port.
EN
170 mm
7 kg
446 g
76 g
100 m
380 × 35 × 35 mm
125 × 53 × 22 mm
04