LG DLEX7601 Serie Manual Del Propietário página 53

Before Calling for Service
This dryer is equipped with an automatic error-monitoring system to detect and diagnose problems at an early
stage. If the dryer does not function properly or does not function at all, check the following before you call for
service.
Operation
Problem
TM
The Flow Sense
indicator remains
active after clearing
the restriction in the
venting.
Dryer will not turn on
Dryer does not heat
Display show error
code nP or gAS
Possible Cause
After clearing the restriction, the
TM
Flow Sense system requires
multiple, consecutive cycles to
determine that the performance
value has improved before the
TM
Flow Sense indicator is reset.
Power cord is not properly
plugged in.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
House fuse is blown, circuit
breaker has tripped, or power
outage has occurred.
Gas supply or service is turned
off (gas models only).
Energy Saver option selected
(on some models)
Power cord connection is
incorrect.
Gas supply or service turned off
(Gas models only).
TROUBLESHOOTING
Solutions
TM
If the Flow Sense indicator remains
active for more than five cycles after
the restriction has been cleared, call for
service.
Make sure that the plug is securely
plugged into a grounded outlet matching
the dryer's rating plate.
Reset circuit breaker or replace fuse. Do
not increase fuse capacity. If the problem
is a circuit overload, have it corrected by
a qualified electrician.
Reset circuit breaker or replace fuse. Do
not increase fuse capacity. If the problem
is a circuit overload, have it corrected by
a qualified electrician.
NOTE
Due to the design of electric dryers,
it is possible for a circuit problem to
allow an electric dryer to run without
heat.
Confirm that the house gas shutoff and
the dryer gas shutoff valves are both fully
open. Even if gas is not supplied to the
dryer, it will run and no error codes will
display. Verify that other gas appliances in
the home are working normally.
If using the Cotton/Normal cycle, deselect
the energy saver option. The Energy
Saver option is selected by default. This
option reduces energy use by adding
an air dry section to the beginning of the
cycle. It is normal to feel no heat at the
beginning of the cycle while in Energy
Saver mode.
Check the connectriction of power cord to
the terminal block.
Confirm that house gas shutoff and the
dryer gas shutoff are both fully open
53