THOMSON WS702 Manual De Instrucciones página 16

TV Audio input
1. Connect the TV AUDIO on the speaker to the TV out port of the TV with a High speed
cable.
2. Select the "GREEN" LED indicator by pressing the "TV" button on the remote or press the
mode/volume button.
3. Set the TVs audio output to "PCM". (More information on PCM page).
USB input
1. Insert a USB drive into the USB A port on the rear.
2. Select the "PINK" LED indicator by pressing the "TV" button on the remote. Or press the
mode /volume button.
3. The maximum size of USB media for MP3 playback should not exceed 32GB.
Optical input
1. Press the mode/volume button to select the optical input. The indicator turns light white.
2. Use the appropriate optical cable to connect an audio source to the speakers.
3. Play music from your connected device and adjust the volume on your device or by turning
the "Mode" button.
Bluetooth operation
1. Select the "BLUE" LED indicator by pressing the "BT" button on the remote, or press the
mode/volume button.
2. Go to setup section on your source device (mobile phones, tablets, etc ) and search for
nearby Bluetooth device to find "WS702" in the list.
3. Pair your device with "WS702".
4. Play the audio tracks on your device and adjust the volume according to preference.
5. Double-tap quickly to disconnect Bluetooth.
Setting the electronic control module (PCM) on your TV
If there is no sound from TV or Speaker when all cables are connected properly and the LED
indicator light is correct (Optical or digital connection) , adjust your TV settings as below:
1. Press the "Menu" button on the TV remote control.
2. Select "Audio Settings".
3. Select "Advanced Audio" - some TVs may not have an "Advanced Audio" menu and instead
display a list of audio settings.
4. Select "Audio Output Mode" or "Digital Audio Output Mode".
5. Select "PCM" as the audio output mode.
6. Press "OK" to save the settings
Digital audio output settings may differ by brand, so please check your TV's instruction manual.
Auxiliary ouput
You can add external speaker to WS702 by plugging in a 3.5mm jack cable to the auxiliary
output on back panel. This will output the sound to another speaker.
Subwoofer output
You can add external subwoofer to WS702 by using the subwoofer output. It will reinforce low
frequency.
- EN 16 -