Publicidad
1. Power
After connecting power adapter, the unit will power on automatically for the first time.
When it is on, press and hold power button for approximately 3 seconds to access reboot
or power off menu. Short press on power buttom will turn off/on screen /but leave the
photo frame in on position).
2. Reset
Use a needle or paper clip to reset unit.
3. USB
Connect with a USB flash driver via OTG cable （not included) or connect to a computer to
transfer data. Can import photos from USB disk/computer to photo frame,can't copy
photos from photo frame to USB disk/computer, can't playback photos from USB disk
directly. Note: The micro USB port is only for data transfering, not for charging.
4. Micro SD
Load external microSD memory cards here. Note: Consumer can import photos from
micro SD card to photo frame,can copy photos from photo frame to microSD card,but
can't playback photos from micro SD card directly.
5. DC
Connect DC adapter to power on the device
6. Wall mounting holes
Use the screw to mount the frame on wall, portrait and landscape available.
Getting started
Thank you for purchasing your very own frameo.
Follow the on screen guide when powering it on for the first time.
Once you have set up your frameo, start connecting it to your friends and family.
Frameo app
To send photos to your frame, use the frameo app for iOS or Android.
Frameo quick setup
When starting your frame for the first time, you will need to setup the frame.
All settings can be changed through the settings menu afterwards.
• First you start by selecting a language. This will be the language used throughout
frameo.
• Connect your frame to the internet by connecting it to a wi-fi.
If a newer version of the frameo software is available, then you will be prompted with an
update dialog. It is recommended to update your frame immediately if prompted.
• Enter your name, and the location where you have placed your frame e.G. "Living room",
"kitchen" or "office".
9
Publicidad
